[FC] Steves door latch

[Mike Gauthier]

Keith,

Great work on the tank.  This one will outlast your Rampy!.  Sometimes, it's 
better to make your own part then to try to get a used one.  I am trying to 
fabricate an hinge for my ramp door (long story).  Next time you get close 
to your rampside, I would appreciate if you could verify approximately at 
what angle the portion of the hinge that bolts to the truck bed is bent 
downward?.  I have a schematic of the ramp door (form the assembly manual) 
but it's not clear enough if it's a 45 or 90 degree!.

Many thanks,

Mike Gauthier.

>From: "Keith Hammett" <khammett at stainlessfab.com>
>Reply-To: khammett at stainlessfab.com,   The Corvanatics list 
><corvanatics at corvair.org>
>To: "'The Corvanatics list'" <corvanatics at corvair.org>
>Subject: RE: [FC] Steves door latch
>Date: Thu, 19 May 2005 15:10:00 -0500
>
>Tim,
>
>I decided that I wanted a new tank and new sender for my rampy.  The tank 
>is
>about done, just need some finishing touches put on it.  Check it out at
>http://community.webshots.com/user/cvair
>
>Keith Hammett
>
>-----Original Message-----
>------snip------
>This site and the virtual vairs are your best bet. I was able to get a
>vendor to to a gas tank sender rebuild here and free advice on how to
>best re- seal my Rampy gas tank here.
>
>_______________________________________________
>Corvanatics mailing list
>Corvanatics at corvair.org
>http://www.vv.corvair.org/mailman/listinfo/corvanatics
>This list sponsored by the Corvair Society of America, 
>http://www.corvair.org/

_________________________________________________________________
Take advantage of powerful junk e-mail filters built on patented Microsoft® 
SmartScreen Technology. 
http://join.msn.com/?pgmarket=en-ca&page=byoa/prem&xAPID=1994&DI=1034&SU=http://hotmail.com/enca&HL=Market_MSNIS_Taglines 
  Start enjoying all the benefits of MSN® Premium right now and get the 
first two months FREE*.