[FC] Stripping the Greenbrier... hinge seals...

[Merv Krull and or Loretta Prosser]

thanx Ken!
mk
----- Original Message ----- 
From: <VairMech at aol.com>
To: <corvanatics at corvair.org>
Sent: Monday, February 28, 2005 4:21 AM
Subject: Re: [FC] Stripping the Greenbrier... hinge seals...


>
> In a message dated 2/27/2005 11:44:08 P.M. Eastern Standard Time,
> krupross at sunwave.net writes:
>
> Anyone  with any good ideas how to replace those rubber 'seals' where the
> hinge arm  goes through the body sheet metal without taking the door  off?
>
>
>
>>>>>>>>>>>>>>>
>    There are a couple of different ways to do this,  ONE, cut the seal and
> just leave the inner half there. Then take the new seals,  cut them in 
> half and
> glue them to the body.
>    Two, Remove the hinge from the body and then remove  like any other
> grommet and install them before you put the hinges back  together.
>    Ken Hand
> _______________________________________________
> Corvanatics mailing list
> Corvanatics at corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/