[FC] Installing Emblem on rampside tailgate.

[Dennis & Debbie Pleau]

In this day and age, I would cut off the posts and use one of the modern 
adhesives to glue the emblem on.

dp

At 07:09 PM 12/5/2005, James Davis wrote:
>I put the clips in the "Chevrolet"  and push it into the four holes.  If 
>it doesn't go in easily, just enlarge the holes with the next larger 
>numbered drill bit or a 1/2 inch tapered reamer
>Jim Davis
>
>.
>At 03:05 PM 12/5/2005, you wrote:
>>My ramp is out of the paint shop and I am in the process of putting it back
>>together. (No small job)   I am trying to install the "Chevrolet" emblem on
>>the tailgate.  I have the little clips sold by Clark. #C3673, just like the
>>originals that were consumed by rust. Actually the tailgate, emblem and
>>studs are in excellent condition.  What is the correct way to install this
>>emblem?  Do I put the clip on the tapered stud then push into the tailgate?
>>Or put the stud in the tailgate hole, then push the emblem with its studs
>>into them?  I have sort of tried both ways, but am afraid to put much force,
>>for fear of ruining something.  It feels very hard to push and the tailgate
>>sheet metal bends in slightly.  I'll wait doing this until I hear from you
>>folks who have done this lots of times.  Thanx.
>>George.