[FC] MY Wiring harness answer

[corvanatics@corvair.org]

i made my own harness for both the rampy and the greenbrier.  i used good 
wire from the center harnesses i took from cars i parted out. i took all the tape 
off the bad harness..layed out on bench and made the new  using connectors 
and dimensions from the old one , plus i added wires for tach and trailer 
harness hookup. i found wide tape with and without sticky on it at hamfests cheap. 
it takes patience but it can be done and i am happy with the dollars saved to 
put towards interior stuff i can not do. next i will be doing the lakewood this 
winter.     make sure you do not cut or try to solder the coil resistor 
wire(that is probaly the shaggiest wire in the harness) . regards tim colson