[FC] FC block

[Diane Galli]

Hey, guy's,    I have several FC blocks (filler hole in the side), but short 
stroke. I can modify them in my mill, as per page 64 in Bill Fisher's "How 
To Hotrod" in about 20 minutes. I Don't do the shipping and handling well. 
If you could pick them up, you could have all you want for about $25.00 
each. Of course, you won't have that "numbers match" baloney, but they will 
all work.   And they are in California.
       Bob
----- Original Message ----- 
From: "Rad Davis" <rad.davis@mindspring.com>
To: <corvanatics@corvair.org>
Sent: Thursday, December 02, 2004 8:20 PM
Subject: Re: [FC] FC block#TO820RS,my book says it's a 95 standard 65


> Tim,
>
> If it really is an FC block (has the oil filler hole on the side) and it's 
> also long-stroke, I'm looking for one.  I'm in Pittsburgh, PA, so it's not 
> all that far away...
>
> Rad Davis
>
>
> At 04:22 30/11/2004 -0500, you wrote:
>>a friend has this block among lots of engine blocks that are going to be 
>>sold
>>cheap.  if any interest i can reply with contact info off list.  it is
>>located near rochester ny.  if you own a 65 van with std shift and wrong 
>>block here
>>is your rare chance..
>>FC block#TO820RS,my book says it's a 95 standard 65  fc
>>email me off list for info. i will check as often as situations allow.
>>regards , tim colson
>>_______________________________________________
>>Corvanatics mailing list
>>Corvanatics@corvair.org
>>http://www.vv.corvair.org/mailman/listinfo/corvanatics
>>This list sponsored by the Corvair Society of America, 
>>http://www.corvair.org/
> _______________________________________________
> Corvanatics mailing list
> Corvanatics@corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics
> This list sponsored by the Corvair Society of America, 
> http://www.corvair.org/