[FC] 140 dual/single exhaust

[corvanatics@corvair.org]

My only question is should the exhaust pipes before the "Y" be of equal 
length?  Most the ones I see online (V6)seem to be the same length. I know 
this would pose a problem to the corvair but that is part of the challenge :)
Harry


Quoting Bryan Blackwell <bryan@skiblack.com>:

> "Sounds" pretty good.  I've been thinking about converting Red's 
> exhaust to 140 logs and doing a similar crossover.  Whitney sells pre 
> bent tubes if you can't find a local place to bend for you.  Another 
> possibility is a hot rod shop, they often need to do some exhaust 
> fabrication.
> 
> --Bryan
> 
> On Tuesday, August 17, 2004, at 09:08 AM, Williams, Rickie wrote:
> 
> > My Greenbrier w/ 140PG has single exhaust.  I cut the second turn off 
> > of one
> > "U" pipe to form a right angle pipe for the left side of the motor,
> > scavenged thru the recycle pile at the muffler shop and found the 
> > piece I
> > needed to make the dip under the transaxle, and then "siameeezed" that 
> > piece
> > into another "U" pipe on the right side of the motor.
> >
> --
> Bryan Blackwell bryan@skiblack.com
> http://autoxer.skiblack.com/
>    Corvairs: '61 Lakewood, '64 Greenbrier, '65 Corsa, '66 Corsa
>    '69 Road Runner, '97 Ford F-150, '99 Neon R/T
> "Why do something if you're not going to obsess about it?"
> _______________________________________________
> Corvanatics mailing list
> Corvanatics@corvair.org
> http://www.vv.corvair.org/mailman/listinfo/corvanatics
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/