BSCC- Selling my Corvair parts inventory

[Chuck Cromwell]

Mark.
Yhe case cu210. does it have a speedometer drave in it?
----- Original Message -----
From: Mark Edmonds
Sent: 10/05/13 11:18 AM
To: Bay State Corvairs \(MA\)
Subject: BSCC- Selling my Corvair parts inventory

Hello everyone. Now that my garage is Corvair-less I am getting rid of my parts inventory. Below is a list of some of the stuff. I will soon be putting these parts on Virtualvairs, Corvair Forum, Ebay etc. so let me know if you want something.
Transmission and differentials would be for pick up here. Or, if I get enough club buyers for some of the bigger stuff I will load up the truck with big and small parts and bring to a meeting to save everyone shipping. Like many people I probably have enough stuff to do my own swap meet. I included Clarks part numbers for reference.
I have a lot more stuff than listed below.
Additionally I have a section of wall covered by small parts (grommets, seals, odds and ends pieces) still in bags from Clarks, hanging on screws. I rather sell them as a whole instead of as individual parts at a couple dollars a piece. At Clarks prices they total about $250. I would like to sell the whole lot for $125. If you are interested I can send you a complete list.
If you are interested in something (or want to ask me if I have something you need that is not listed) you can reply via email or call me – 860*774*1473
Mark Edmonds

cu671
3.27 differential - 66-69 - ran in Corsa for 1 yr (2006) prior to installing 3.55 diff.
$ 75.00

cu1176
3.55 posi diff. - 66-69 – was on turbo drivetrain - switched to 3.27 diff.
$ 175.00

cu216Z
4 speed transmission - 66-69 - checked out OK by Terrys Transmissions April 2011
$ 200.00

Differential - AF= 65-69 3.55 PG - yokes turn, gears “frozen”
$ 15

65 AD differential - (3.55 posi) yokes turn, gears “frozen”
$ 50.00

cu210
Differential empty case - 66-69
$ 0

4 speed Transmission gear set – 66-69 – needs shaft and rebuild – with case
$ 75

 rear springs - 15" x 0.560" dia. - pair
$ 10

cu272
Lower control rod brackets (at differential) – pair
$10

C11735
lower control rods (strut rod) - rubber outer and nylon inner bushings – used in Corsa about 4 years until switched to polyurethane – some wear but still usable - pair
$ 25.00

C1498, 1499
Stainless Steel Stabilizing Rod (trailing arm to transmission) from Corvair Underground - about 500 miles on them – pair – painted black
$ 25.00

C6156XR
Clarks rebuilt rear wheel bearing unit – right – never installed
$ 100.00

C2841
Used - Clarks adjustable rear shocks - pair - Gabriel - Made in USA - P6053 4202-0435
$ 35.00

C6765B
Koni front shock top rubber - new in bag - pair
$ 10.00

140 engine for rebuild – has alternator, carbs, most of carb linkage, distributer, exhaust logs, some shrouds – turns by hand
$ 250.00

top engine fan shroud - 140
$ 5.00

top engine fan shroud - non 140
$ 5.00

cu57
bellhousing – standard transmission GM3832176
$ 10.00

cu58
bellhousing - PG transmission - GM 3832517
$ 10.00

Block cover and fan pulley
$ 5.00

cu333
turbo intake crossover - chrome
$ 10.00

headers and mufflers - (pre 1992 Clarks?? - mufflers are different lengths)- pair – tubes rusty but still usable – tube dia. = 1.35” – will fit 140 and should work on other engines as well
$ 35.00

c320/320A
Three front wheel bearings (BR6 - inner - NAPA / SKF) and four front wheel bearing seals -- (all new in box)
$ 25.00

Rear deck lid (engine lid) with support – dark blue – no trim (also have a lid with hole cut in it for the turbo air intake I ran for a while that has the rear trim piece)
$0

 *Non-Corvair*

Chevy Transmission - 4 speed/OD manual - from 1980's Chevy pickup – will mate to SBC (had it on 327)

Chevy Truck transmission - 4 speed manual with PTO from 1970's C30 dump

Chevy transmission - 3 speed manual - Saginaw

Quadrajet carburetors (2)
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.vv.corvair.org/pipermail/bsc-list/attachments/20131008/c72f7594/attachment-0001.html