BSCC- Fwd: Corvair question

[David McMillan]

I could be wrong, but I think it means just loosen the
screw enough to "rotate" the plate and tighten using
the same screw and hole...some people would just
remove the plate for the winter...recycles the heat
off the exhaust back into the engine compartment.

Dave

--- rick macdonald <rick4130 at yahoo.com> wrote:

> Anybody with an answer to Mike's question??
> 
> Note: forwarded message attached.
> 
> 		
> ---------------------------------
>  Yahoo! FareChase - Search multiple travel sites in
> one click.  > Date: Sun, 23 Oct 2005 15:16:49 -0400
(Eastern
> Standard Time)
> From: "Mike Hill" <mhill at adelphia.net>
> To: "Rick McDonald" <rick4130 at yahoo.com>
> Subject: Corvair question
> 
> Hi Rick,
> 
>   I was working on my bus today getting it ready for
> winter. I noticed a
> small plate at the rear of the engine below the
> generator. The plate say it
> should be rotated 180 degrees in the winter to
> provide carb pre-heating. I
> removed the single screw and rotated the plate 180
> degrees, but there's no
> way to screw the plate back down when I turn it.
> There's no screw hole. Do I
> need to drill a hole or am I missing something. 
> 
> Thanks, 
> ...Mike> No virus found in this outgoing message.
> Checked by AVG Anti-Virus.
> Version: 7.0.344 / Virus Database: 267.12.4/146 -
> Release Date: 10/21/2005
> >  _______________________________________________
> This message was sent by the BSC-list mailing list,
> all copyrights are the property
> of the writer, please attribute properly. For help,
> mailto:bsc-list-help at corvair.org
> This list sponsored by the Corvair Society of
> America, http://www.corvair.org/
> Post messages to: BSC-list at corvair.org
> List info:
> http://www.vv.corvair.org/mailman/listinfo/bsc-list 
>  _______________________________________________



	
		
__________________________________ 
Yahoo! Mail - PC Magazine Editors' Choice 2005 
http://mail.yahoo.com